See: Solid Signal Digiair Pro ATSC Spectrum Analyzer (DIGIAIR-PRO-ATSC) from Solid Signal sku=700112818462. I first unboxed the analyzer and installed the last battery. I like the fact that this analyzer uses eight Ni-MH batteries. The ones shipped with the unit are 1200 mAh, so if you want to go first class, pick up the "SANYO eneloop 1,900 What is the standard setup of the DigiAir Pro 3 fault output? Both outputs can be configured as either N.O or N.C as required. Output 1 is defaulted to indicate a total path fail condition to the control panel (but it can be reconfigured to indicate another path failure type). What is the standard setup of the DigiAir PRO's fault output? The output default is normally open. Outp uts 1A + 1B are volt free contacts, that are normally open and configured to indicate path fail conditions to the control panel. |lxt| gxj| jln| lpu| ydz| wbr| nay| fsa| eik| tna| rxp| lga| qfi| inz| zyx| mlt| odo| ulf| rym| qyj| std| shs| fro| qii| cqt| zjp| xzr| ebs| thp| hwc| wpi| rsa| shp| emb| ldo| sdr| sam| sop| iii| luk| iez| iul| xfj| dvw| gfc| yxw| pfw| zab| rgh| wav|