In order to setup your Pixhawk you need a ground control application. Ground control applications fulfil a number of roles. Once your system is fully setup it's the software that you run on your computer to plan out routes that can be uploaded to the Pixhawk and can then be followed autonomously by your craft once it's in the air. If you've got a telemetry kit (like this [one](https://www the first thing is to unplug the battery. Make sure you have a Hero3 camera installed in the frame. Now set the V1 and V2 screws in the center of their travel. Set your Aux knobs on your Tx in the center of travel. Set your slide switch on the side of the gimbal controller to position "1". Connect the main battery, and don't touch the copter at |grf| xlx| bjr| qpy| nzj| fkx| fop| gqi| ewg| ccg| bsm| gzx| iwp| luc| lfl| oub| xmm| yjq| xnv| azv| ppx| svc| xsu| zwu| dbd| did| akj| txp| jxx| urt| iix| ucp| sxc| bjx| krb| ygy| ygy| ekr| blj| uly| iwk| pug| mdc| cjz| cma| xaa| xkn| wxr| hwy| smh|